Contents
How do I delete guide points in SketchUp?
There is no Edit>Delete Guides in SketchUp Free. Instead go to Display and click on Delete Guides. You might get this same issue if you created your guides while editing a group or component and you have closed the edit session. Simply enter the group or component and delete the guides.27 mar. 2020
How do I change the tape measure in SketchUp?
1. Select the Tape Measure tool on the toolbar or the Tools menu.
2. To put the Tape Measure in Measure mode, press the Ctrl key (Option on the Mac) so that the plus sign (+) next to the Tape Measure cursor disappears.
How do I get rid of ghost lines in SketchUp?
How do you clean a tape measure?
How do you hide the lines on a SketchUp tape measure?
Right-click a single guide and choose Hide to hide it, or deselect View, Guides to hide them all. It’s a good idea to hide your guides instead of erasing them, especially while you’re still modeling. Select, move, copy, and rotate guides just like any other entity in your model.
How do I make a guide in sketch?
What does Tape Measure tool do SketchUp?
In SketchUp, the Tape Measure tool, the Protractor tool, and the Measurements box enable you to model precisely: With the Tape Measure tool ( ), you can measure a distance and set precise guide lines or guide points. Note: Guide lines and guide points are temporary dashed lines used as guides to draw precisely.
What is a pull push rule?
What is Pull Push Rule? A push pull rule is a measuring tape that coils into a compact case. It is used for measuring long, short, straight lengths.
What is the shortcut key used for Tape Measure tool?
Select the Tape Measure tool. Press Ctrl (Option on a Mac) until you don’t see a + next to your cursor. Measure a distance; click once to start measuring, and again to stop.
How do you smooth lines in SketchUp?
To smooth edges with the Eraser tool, hold down the Ctrl key (Option on the Mac) while you click or drag over the edges you want to smooth. Use the Soften Edges panel. Located on the Window menu, this panel lets you smooth a bunch of selected edges all at once, according to the angle of their adjacent faces.
How do I remove a mesh line in SketchUp?
Select your component, right click and choose Soften / Smooth Edges. This will open the Soften Edges tray (assuming you are using SketchUp 2018). Make sure “Smooth Normals” is checked and then adjust the Angle slider until you get the result you want.1 juil. 2017
How do you clean up in SketchUp?
Why don’t you pull the steel tape too much?
Do not pull the steel tape of pull-push rule too much to avoid the coil spring from damage. Do not use the caliper as tongs.8 mar. 2021
Why do tape measures twist?
When you make a measurement, and especially when you mark it, make sure the side of the tape is flat against the surface where you mark it. The tape is naturally cupped out from the surface, so just give it a twist to get one edge flat against the surface.15 nov. 2015
How long do tape measures last?
I usually return it every 3 to 4 months for new one.26 mar. 2007