Lesson56- More Practice TRACKING



Open the T109_5.dwg in your personal folder and create the boundary LINEs for the missing section view as shown.

– use tracking techniques ONLY.

– do NOT use construction lines

– do NOT use Fillet, Offset or Trim commands.

– hatching is not required.

Open the T109_6.dwg in your personal folder and create the missing top view as shown.

– use tracking techniques ONLY & use appropriate layers.

Open the T109_7.dwg drawing in your personal folder and complete the side, auxiliary & profile views as shown below.

– there is sufficient information in the existing geometry and in the 3D sketch below to complete these three views.

– use tracking techniques along with Parallel & Extension osnap tools as much as possible to complete these views.

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment moderation is enabled. Your comment may take some time to appear.

Show Buttons
Hide Buttons
SUBSCRIBE TO OUR NEWSLETTER

It's FREE!

Sign up and receive an email every time a new tutorial is published