How to make slab design in autocad?

1. Open the Design tool palette, and select the Slab tool or the Roof Slab tool.
2. On the Properties palette, click the Design tab, expand Basic, and expand General.
3. Under Style, select a slab or roof slab style.

Also, how do I create a two way slab in Autocad?

Beside above, how do you Design a slab?

1. One way slab d = (L/22) to (L/28).
2. Two way simply supported slab d = (L/20) to (L/30)
3. Two way restrained slab d = (L/30) to (L/32)

People ask also, how do you draw a concrete slab?

Frequent question, how do you Design a slab depth? The depth of slab depends on bending moment and deflection criterion. the trail depth can be obtained using: Effective depth d= Span /((L/d)Basic x modification factor) For obtaining modification factor, the percentage of steel for slab can be assumed from 0.2 to 0.5%.

What is one way slab in civil engineering?

The one-way slab is a slab, which is supported by parallel walls or beams, and whose length to breadth ratio is equal to or greater than two and it bends in only one direction (spanning direction) while it is transferring the loads to the two supporting walls or beams, because of its geometry.

Which software is used for slab design?

ULS and SLS analysis of reinforced concrete slabs OPTUM MP is the only commercial software package available to offer a completely automated yield-line analysis using Limit Analysis – and at the same time offering calculation of the deflections in the Serviceability Limit State using FEA.

What is the thickness of slab?

In general, 6 inch (150mm) slab thickness is considered for residential and commercial buildings with reinforcement details as per design. Methods used for finding slab thickness varies for different types of slabs.

How is design load of slab calculated?

Let, Assume the slab has a thickness of 150 mm. Slab Load Calculation = 0.150 x 1 x 2400 = 360 kg which is equivalent to 3.53 kN. Now, If we consider the Floor Finishing load to be 1 kN per meter, superimposed live load to be 2 kN per meter, and Wind Load as per Is 875 Near about 2 kN per meter.

How do you draw a beam in AutoCAD?

move the cursor over a segment of the grid to display a preview of the beam, and then click to add a beam along that segment; or press Ctrl and click to add beams along all segments in that grid line; or press Ctrl twice and click to add beams along all segments in the grid. Press Enter to end the command.

How do you make a concrete form?

How do you make concrete steps?

What is slab in RCC?

A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete.

What are the types of slabs?

1. One-Way Flat Slab.
2. Two-Way Flat Slab.
3. Kitchen Slab.
4. Sun Shade Slab.
5. Lintel.
6. Sunken Slab.
7. Cable Suspension Slab.
8. Pre-Tension Slab.

What is a slab plan?

Slab house plans are the easiest foundation type. They are flat concrete pads poured directly on the ground. They take very little site preparation, very little formwork for the concrete and very little labor to create.