Frequent question: What is the opposite of explode in autocad?

There is no “unexplode”: you can use BLOCK command or BEDIT command to make a new block. Hi, the command you are looking for is “join”, it will connect all the lines you select.

Also, how do I merge after explode in Autocad?

Additionally, what is the difference between burst and explode in Autocad? BURST is best used any time you need to explode a block or object but would like to preserve the Attribute values of the block instead of reverting them back to the default value. If you were to use the EXPLODE command, the block layers are also preserved when using the BURST command.

As many you asked, how do I merge lines in Autocad?

1. Click Home tab > Modify panel > Edit Polyline. Find.
2. Select a polyline,spline, line, or arc to edit.
3. Enter j (Join).
4. Press Enter to end the command.

Subsequently, what is osnap AutoCAD? The Object Snap is used to specify a precise location on the objects. It displays the points on the objects, such as midpoints, center point, quadrant point, insertion point, endpoint, etc., which make the drafting and drawing process effective.

How do you hatch in AutoCAD?

1. Click Home tab > Draw panel > Hatch.
2. On the Properties panel Hatch Type list, select the type of hatch that you want to use.
3. On the Pattern panel, select a hatch pattern, such as ANSI31.
4. On the Boundaries panel, click Pick Points.
5. Click inside the circle, rectangle, and the triangle.

Can you undo explode in AutoCAD?

What is extend in AutoCAD?

The extend command is used to extend the selected boundaries or edges. The objects are extended so that the edges of other objects can be converged.

What is fillet in AutoCAD?

The fillet command is used to create rounded edges between the adjacent lines and faces in 2D and 3D. It is also used to connect two tangent arcs in 2D.

What is difference between burst and explode?

As verbs the difference between burst and explode is that burst is to break from internal pressure while explode is to destroy with an explosion.

How do you close a gap in AutoCAD?

Start the PEDIT command and at the first prompt, choose the Multiple option and select both objects. Then use the Join option. At the Enter fuzz distance or [Jointype] <5.0000>: prompt, enter a number larger than the gap to close it, and end the command. Use the Jointype suboption to specify how the gap is closed.

How do I fix a broken line in AutoCAD?

1. Unlock, thaw, and turn on all layers.
2. Choose a point close to the objects and note down its coordinates.
3. Type MOVE and press Enter.
4. Type ALL and press Enter.
5. Choose the previously determined point as a base point and 0,0 as an end point.
6. Save and close the drawing.

How do you extrude in AutoCAD?

1. Select Extrude command from the ribbon panel, as shown below: Or. Type Extrude on the command line < press Enter.
2. Select the object, which we want to Extrude. Here, we have selected the rectangle.
3. Press Enter.
4. Now, specify the height of the Extrude. We can specify the height in +Z or –Z direction.

What is snap and osnap?

snap is an incriment tool, it alows you to move work in specific increments, the increments can be chaged at any time. osnap is object snap, snaps to a specific part of an object.

What is Polar Tracking in AutoCAD?

Polar tracking restricts cursor movement to specified angles. PolarSnap restricts cursor movement to specified increments along a polar angle. When you create or modify objects, you can use polar tracking to display temporary alignment paths defined by the polar angles you specify.