Contents
How do you use the Bend tool in Inventor?
1. Model a part and invoke a sketch on the surface about which you will bend it.
2. Create a line about which bending will initiate.
3. Click on the arrow mark shown in the picture just below the “modify” tool bar.
4. Select bend part.
How do you make a flexible part in Inventor?
1. Create an assembly that contains the required degrees of freedom.
2. Right-click the placed subassembly in the graphics window or the browser, and then select Flexible.
3. Continue to select subassemblies and make flexible, as needed.
4. Click Save to preserve flexible states in the assembly file.
How do you bend extrusion in Inventor?
How do you add a bend line in Inventor?
On the ribbon, click Annotate tab Feature Notes panel Bend . In a flat pattern drawing view for a sheet metal part, select a bend centerline (or do a window selection for multiple bend centerlines). Bend note is generated and placed about the selected bend centerline. Right-click and select Done to finish the command.14 avr. 2021
How do you bend a bar in Inventor?
How do you fold an inventor?
1. On the ribbon, click Sheet Metal tab Create panel Fold .
2. Click the bend line to use for the fold.
3. In Fold Location, click one of the following to specify whether the line defines the centerline, start, or end of the bend:
What is flexible inventor?
You can use Flexible to expose the allowable movement defined in the subassembly in the parent assembly. … When the cylinder is inserted into the upper level assembly, the freedom of movement allowed in the subassembly is not exposed in the parent assembly.14 avr. 2021
How do you use adaptive in Inventor?
1. Right-click the work feature in the browser or the graphics window, and then select Adaptive.
2. On the ribbon, Assemble tab Position panel Constrain.
3. Constrain the work feature to parts in an assembly to make it adapt to changes in the parts.
How do you bend an extrusion?
In the hydraulic rotary draw bending process, manufacturers place extruded aluminum onto a bender and hold it in place with a stationary or sliding pressure die and clamping block. The round bending die, powered by hydraulics, is rotated up to 90 degrees, bending the extrusion as it rotates.
How do you make a contour flange in Inventor?
1. On the ribbon, click Sheet Metal tab Create panel Contour Flange .
2. On the Contour Flange dialog box Corners tab, select Apply Auto-Mitering.
3. At the prompt, select an edge. Select multiple edges to generate flanges using values that you enter.
How do you change the bend radius in Inventor?
On the Notes and Leaders tab, select Bend Note Settings. If needed, edit the default bend note text in the edit field: Click Bend Direction, Bend Angle, Bend Radius, or kFactor in the Values and Symbols section to insert the corresponding property in the edit field.14 avr. 2021
How do you insert a flat pattern in Inventor?
1. Click Place Views tab Create panel Base .
2. In the Drawing View dialog box, select a sheet metal component as File.
3. In the Sheet Metal View area, select Flat Pattern view.
4. If appropriate, select or clear the selection of the Recover Punch Center option.
5. Set other options in the Drawing View dialog, and then click OK.
How do I draw a curved line in Autocad?
1. Click Home tab Draw panel Polyline. Find.
2. Specify the start point of the polyline segment.
3. Specify the endpoint of the polyline segment.
4. Specify additional polyline segments as needed.
5. Press Enter to end, or enter c to close the polyline.
How do you make a pipe in Inventor?
1. With an assembly file open, click Environments tab Begin panel Tube and Pipe .
2. In the Model browser or graphics window, right-click the blank area and select Create Pipe Run.
3. Do either of the following:
4. Click OK to close the dialog box.